Jantex Discharge Base FS SWEET is a PREMIUM discharge ink system used for printing onto dark garments.  The Jantex Discharge Base FS SWEET can be used "as is" to achieve a neutral ground color or concentrated pigments may be added to replace the original garment color in one print.

Jantex Discharge Base FS SWEET has a soft hand feel and is easy to print through a wide variety of mesh counts.  The "FS SWEET" version has a higher concentration of binder (glue) for superior adhesion as well as extra lubricant for easy printing.   It also includes a blueberry scent that helps mask the odor that is normally associated with discharge printing.  

When ready to print, add Jantex Parolite (activator) at up to 6% by weight and mix well.
Do not prepare more than needed as the discharge base has a shelf life of approximately 8 hours after activation.

Each substrate will react to discharge differently and some garments do not discharge.  Please check with your garment supplier and test thoroughly before running any production. 

Using Discharge as an Underbase

Follow the standard procedures for printing discharge base with the Jantex Parolite already added to the base.  After printing, use a strong flash so that the inks are dry to the touch.  Ideally, you should see the discharge process already well underway.  Proceed with printing as normal.  Be careful as longer flashes will create hot pallets that can have an affect on ink drying in screens.  Cure the garment according to normal discharge ink requirements.  

Sizes Available: